130 Bush St

130 Bush St is a 14-story building in Downtown San Francisco with 100% of its floor area within daylight reach of a facade. This screen estimates 186 homes and scores it 100 out of 100 for office-to-residential conversion suitability.

CA-11 · Screened 2026-10-12 · Strong candidate

Build a free conversion planCheck its numbers, lay out its homes and get a two-page PDF. Free.

No address point in San Francisco’s records falls inside this footprint, so it is named by the closest one that no other screened building claims — usually a site entrance, but check the outline on the plan below before relying on the street number.

Where 130 Bush St is

Its block in Downtown San Francisco, drawn from San Francisco's own building outlines and street centerlines.

266 Bush St: scores 100 out of 1001 Bush St: scores 100 out of 100465 California St: scores 100 out of 100200 Bush St: scores 100 out of 100101 Montgomery St: scores 100 out of 100235 Pine St: scores 100 out of 100220 Bush St: scores 100 out of 100225 Bush St: scores 99 out of 100240 Montgomery St: scores 99 out of 100160 Sansome St: scores 95 out of 10031 Front St: scores 95 out of 100475 California St: scores 94 out of 100155 Sansome St: scores 92 out of 1002 Battery St: scores 92 out of 100234 Bush St: scores 92 out of 100340 Pine St: scores 91 out of 100369 Pine St: scores 91 out of 100100 Battery St: scores 90 out of 100111 Battery St: scores 90 out of 10098 Battery St: scores 88 out of 100295 Bush St: scores 83 out of 10021 1st St: scores 81 out of 1001 Sansome St: scores 76 out of 10040 Battery St: scores 68 out of 100100 Montgomery St: scores 65 out of 100425 Market St: scores 55 out of 100525 Market St: scores 46 out of 10010010010010010099959492929291918846100SANSOME STBUSH STBATTERY STPINE STCENTURY PLEXCHANGE PLTREASURY PL1ST STMARKET STN100 ftDowntown San Francisco
Suitability score
0–29
30–49
50–69
70–100
  • Already housing
  • Not screened
  • 130 Bush St
130 Bush St and the 1,000 ft of Downtown San Francisco around it. The streets are drawn at the width of the right-of-way they run down, sidewalks included, and named, and every building on these blocks is drawn. What is left open and stippled is neither: a surface lot, a plaza or a vacant parcel. The screened buildings are colored by the ramp above, the same one the district map uses, carry their score, and each is a link to its own page. Each casts a shadow as long as its measured height lets it, so towers stand out from the low buildings around them; the unscreened buildings have no measured height and cast none. 130 Bush St is outlined in its own score color at the outline it covers at ground level. The inset places it among every building the screen covers.
28 ftAA50 ftDaylit 100%
Floor plan: 100% of each floor sits within daylight reach of a facade, with no dead core at all. The shading is daylight, darkest at the windows and gone 35 ft in. The dimension marks the deepest interior point, 28 ft from the nearest window. A–A is where the section beside it is cut.
No homesDaylit14 floors25 ft
Section A–A: cut across the depth of the plate, through the middle of the core. Daylight reaches 35 ft in from every facade, and here it meets in the middle: the plate is thin enough that no floor is left windowless. The shaded ground floor is converted like the rest and counted as no homes.

This building does not pencil on its own, but a modeled RESIDE Act grant would close the gap if the building qualified for one.

This footprint has no windowless core at all: every point on the floor plate is within 35 ft of a facade, which is unusual and is the main reason it scores as well as it does.

Modeled conversion metrics for 130 Bush St, 2026-10-12.

Suitability scoreStrong candidate100 / 100
Storiesfrom 191 ft LiDAR (2010) height ÷ 12 ft floor-to-floor14
Floor plateper floor, from the city footprint13,474 sq ft
Daylight efficiencyshare within 35 ft of a facade100%
Deepest interior pointviability threshold is 80 ft28 ft
Windowless coreper floor — renovated but never rentable0 sq ft
Estimated homesat 750 sq ft average186
Conversion cost$405/sq ft all-in on 175,166 sq ft$70.9M
Gap before grantshortfall against completed value$2.9M
Modeled RESIDE grantat the statutory per-award cap$10.0M
BuiltSan Francisco's own record of the construction year1908
ZoningFinancial District/South BeachC-3-O
Opportunity Zonenot in a 2018 designated tractNo

The plan: window line, shape and floor rhythm

50 ft of exterior wall for each home the screen estimates — enough for two- and three-bedroom homes across the plan.

The typical floor has 717 ft of exterior wall, and across 13 residential floors the building carries 9,327 ft of it in total, divided among the 186 homes this screen estimates.

Its plate is elongated at 0.33: a slab or an L, which is why so much of the floor lies within reach of a window: the outline buys daylight that a square plan of the same area would not. How window line and plate shape are measured.

At the model’s 750 sq ft average, the plan works out at about 14.3 homes per floor, repeated on every residential floor, since this building's outline does not change as it rises.

Why 130 Bush St scores 100 out of 100

Daylight efficiency 100, Interior depth 100, Scale 100, Finance 100 — each out of 100, then weighted.

Score components for 130 Bush St. Points are the subscore times its weight.

ComponentSubscoreWeightPoints
Daylight efficiency100% of the floor area within 35 ft of a facade, scored from 40% up to 90%10045%45.0
Interior depthdeepest interior point 28 ft from a facade, scored from 80 ft down to 40 ft10025%25.0
Scale186 estimated homes, scored from 0 up to 15010015%15.0
Financecompleted value covers conversion cost with 10% to spare, which tops out the component10015%15.0

Every component scores at or near full marks, so nothing in the geometry or the pro-forma is holding this one back — daylight efficiency carries the most weight of the four.

Built in 1908

San Francisco records this building as going up in 1908, which puts it in the pre-1920 stock.

As a rule, the era that converts most readily: load-bearing masonry, small floor plates laid out before deep-plan offices were possible, operable windows and generous floor-to-floor heights. The usual obstacles are not daylight but hazardous materials, lifts and bringing structure up to current code. That is the era’s general tendency rather than a finding about this building — the model reads an outline and a height, and can see nothing inside — but it is the first thing an architect would want to know, and it colours how much confidence the 100% daylight figure above deserves.

What the conversion would cost

$405 per square foot all-in across 175,166 sq ft of converted floor, or $70.9M in total — about $381K for each of the 186 homes.

All-in cost per square foot for 130 Bush St: base cost plus the code work a change of use triggers.

Base conversion cost$260/sq ft
Seismic retrofit (change of use)$45/sq ft
Plumbing risers to every unit$40/sq ft
Operable windows and glazing$30/sq ft
Additional egress stair$18/sq ft
Fire sprinklers (NFPA 13R)$12/sq ft
All-in$405/sq ft

That cost is charged across every converted square foot, including the circulation and service area that earns nothing directly. Against it the model sets a completed value of $366K a home, which for 186 homes is $68.1M.

What would have to be true

A $2.9M gap before any grant, which the modeled $10.0M closes. What would reopen it soonest: completed value per home 10% down.

The shortfall before any grant is $2.9M. Closing it from the value side means each of the 186 homes finishing at $381K rather than the $366K the model assumes — 4% more. Closing it from the cost side means getting all-in cost down from $405 to $389 per square foot.

A modeled RESIDE grant of $10.0M moves that threshold to $328K a home. That is below the assumed value, which is why this building counts as unlocked by the grant — subject to it qualifying under the law's vacant-and-abandoned test, which this data cannot show.

Each of these, moved on its own, would be enough to undo that for 130 Bush St:

Single-assumption flip points for 130 Bush St, each holding the other three at their defaults.

Completed value per homethe binding constraint — the least this building would need10% downto $328K
Circulation efficiency11% downto 72%
Average unit size12% upto 839 sq ft
Conversion cost per square foot16% upto $301/sq ft

All four are sliders in the survey, where 130 Bush St re-scores against your own numbers.

How it compares in Downtown San Francisco

130 Bush St ranks 1st of the 205 buildings screened here, against a median score of 87.

Its floor plate is better lit than 100% of them, and shallower than 89% of them at its deepest interior point. On size it is the 91st largest by estimated homes. The full survey of all 205 buildings ranks and maps every one of them, and the list by address links each to its own page.

Within Financial District/South Beach and the C-3-O zone

1st of 165 in Financial District/South Beach, 1st of 88 zoned C-3-O — the comparison that shares its rules, rents and streets.

San Francisco places 165 of the screened buildings in Financial District/South Beach. 130 Bush St ranks 1st of them against a median score of 88, the top score in the group. 121 score 70 or more, their median deepest interior point is 47 ft from a facade against this building’s 28 ft, and together they would hold an estimated 40,456 homes. The group’s top scorer is 870 Market St, at 100.

88 of the screened buildings are zoned C-3-O. 130 Bush St ranks 1st of them against a median score of 89, the top score in the group. 76 score 70 or more, their median deepest interior point is 44 ft from a facade against this building’s 28 ft, and together they would hold an estimated 21,444 homes. The group’s top scorer is 266 Bush St, at 100.

Its nearest match in size: 140 Battery St

The screened building closest to 130 Bush St in converted floor area is 140 Battery St: 171,527 sq ft over 14 stories, against 175,166 sq ft over 14 here.

130 Bush St scores 100 to its 83, and with the size held roughly equal most of that lead comes from interior depth: 100 out of 100 here, 57 there (deepest interior point 57 ft from a facade, scored from 80 ft down to 40 ft). On the money they part ways: 140 Battery St falls short even with the modeled grant, while 130 Bush St pencils only with the modeled RESIDE grant. The two stand about 600 ft apart.

Would it qualify for a RESIDE Act grant?

The model awards 130 Bush St $10.0M, on the assumption it qualifies. Whether it does, no published dataset can say.

That figure assumes the building meets the Act’s vacant-and-abandoned test, which turns on code-enforcement and receivership records no city publishes.

It does not sit in a 2018 designated Opportunity Zone, so it would not draw that Section 201 priority.

Other buildings screened near 130 Bush St

The 4 closest the screen also covers, from 160 ft away. They are the colored outlines on the plan at the top of this page.

  • 200 Bush St
    15 stories · 98% daylit · 150 estimated homes · scores 100/100 (Strong candidate)
    about 160 ft away
  • 160 Sansome St
    17 stories · 92% daylit · 147 estimated homes · scores 95/100 (Strong candidate)
    about 170 ft away
  • 235 Pine St
    25 stories · 98% daylit · 248 estimated homes · scores 100/100 (Strong candidate)
    about 170 ft away
  • 1 Bush St
    19 stories · 99% daylit · 327 estimated homes · scores 100/100 (Strong candidate)
    about 220 ft away

A screen, not a feasibility study, from outlines and heights rather than plans: the method and how to correct a figure. If you know this building’s interior, you know what this model cannot see.