282 Almaden Blvd

282 Almaden Blvd is a 9-story building in Downtown San Jose with 65% of its floor area within daylight reach of a facade. This screen estimates 201 homes and scores it 48 out of 100 for office-to-residential conversion suitability.

CA-18 · Screened 2026-09-12 · Marginal

Build a conversion planCheck its numbers, lay out its homes and get a two-page PDF. Free.

Where 282 Almaden Blvd is

Its block in Downtown San Jose, drawn from San Jose's own building outlines and street centerlines.

220 Almaden Blvd: scores 28 out of 100151 Almaden Blvd: scores 16 out of 1002848W San Carlos StAlmaden BlvdN100 ftDowntown San Jose
Suitability score
0–29
30–49
50–69
70–100
  • Already housing
  • Not screened
  • 282 Almaden Blvd
282 Almaden Blvd and the 1,000 ft of Downtown San Jose around it. The streets are drawn at the width of the right-of-way they run down, sidewalks included, and named, and every building on these blocks is drawn. What is left open and stippled is neither: a surface lot, a plaza or a vacant parcel. The screened buildings are colored by the ramp above, the same one the district map uses, carry their score, and each is a link to its own page. Each casts a shadow as long as its measured height lets it, so towers stand out from the low buildings around them; the unscreened buildings have no measured height and cast none. 282 Almaden Blvd is outlined in its own score color at the outline it covers at ground level. Its windowless core is hatched. The inset places it among every building the screen covers.
79 ftAA100 ftDaylit 65%Core 12,730 sq ft
Floor plan: 65% of each floor sits within daylight reach of a facade. The shading is daylight, darkest at the windows and gone 35 ft in. The hatched area is windowless core: 12,730 sq ft per floor that must be renovated but can never be rented as an apartment. The dimension marks the deepest interior point, 79 ft from the nearest window. A–A is where the section beside it is cut.
No homesWindowless coreDaylit9 floors100 ft
Section A–A: cut across the depth of the plate, through the middle of the core. Daylight reaches 35 ft in from every facade, fading as it goes, and the hatched stripe left between the lit edges is floor that gets converted and can never be rented: 12,730 sq ft on the floor the screen scores, and 101,842 sq ft over 8 residential floors. The shaded ground floor is converted like the rest and counted as no homes.

This building does not pencil at default assumptions, even with a modeled RESIDE Act grant.

Every floor carries 12,730 sq ft of windowless core — area that must be gutted, seismically braced and sprinklered but can never be rented as an apartment. Across 8 residential floors that is 101,842 sq ft of cost carrying no revenue.

Modeled conversion metrics for 282 Almaden Blvd, 2026-09-12.

Suitability scoreMarginal48 / 100
Storiesfrom 104 ft LiDAR height ÷ 12 ft floor-to-floor9
Floor plateper floor, from the city footprint36,358 sq ft
Daylight efficiencyshare within 35 ft of a facade65%
Deepest interior pointviability threshold is 80 ft79 ft
Windowless coreper floor — renovated but never rentable12,730 sq ft
Estimated homesat 750 sq ft average201
Conversion cost$405/sq ft all-in on 290,867 sq ft$117.8M
Gap before grantshortfall against completed value$32.4M
Modeled RESIDE grantat the statutory per-award cap$10.0M
BuiltSan Jose does not publish a construction year with this data—
ZoningDowntown San JoseDC
Opportunity Zonecensus tract 06085500800, 2018 designationYes

The plan: window line, shape and floor rhythm

39 ft of exterior wall for each home the screen estimates — enough for two- and three-bedroom homes across the plan.

The typical floor has 989 ft of exterior wall, and across 8 residential floors the building carries 7,915 ft of it in total, divided among the 201 homes this screen estimates.

Its plate is moderately compact at 0.47: a squarish plan, with enough perimeter for a conventional double-loaded corridor. How window line and plate shape are measured.

At the model’s 750 sq ft average, the plan works out at about 25.1 homes per floor, repeated on every residential floor, since this building's outline does not change as it rises.

Why 282 Almaden Blvd scores 48 out of 100

Daylight efficiency 50, Interior depth 2, Scale 100, Finance 68 — each out of 100, then weighted.

Score components for 282 Almaden Blvd. Points are the subscore times its weight.

ComponentSubscoreWeightPoints
Daylight efficiency65% of the floor area within 35 ft of a facade, scored from 40% up to 90%5045%22.5
Interior depthdeepest interior point 79 ft from a facade, scored from 80 ft down to 40 ft225%0.5
Scale201 estimated homes, scored from 0 up to 15010015%15.0
Financeremaining gap is 19% of conversion cost, scored from 60% down to 0%6815%10.3

Most of what it earns comes from daylight efficiency, and what holds it back most is interior depth, at 2 out of 100: deepest interior point 79 ft from a facade, scored from 80 ft down to 40 ft.

What the conversion would cost

$405 per square foot all-in across 290,867 sq ft of converted floor, or $117.8M in total — about $586K for each of the 201 homes.

All-in cost per square foot for 282 Almaden Blvd: base cost plus the code work a change of use triggers.

Base conversion cost$260/sq ft
Seismic retrofit (change of use)$45/sq ft
Plumbing risers to every unit$40/sq ft
Operable windows and glazing$30/sq ft
Additional egress stair$18/sq ft
Fire sprinklers (NFPA 13R)$12/sq ft
All-in$405/sq ft

That cost is charged across every converted square foot, including the 101,842 sq ft of windowless core, which has to be gutted, seismically braced and sprinklered like the rest of the building and then earns nothing. Against it the model sets a completed value of $425K a home, which for 201 homes is $85.4M.

What would have to be true

A $32.4M gap before any grant, $22.4M after the modeled one. The smallest single change that would close it: average unit size 21% down.

The shortfall before any grant is $32.4M. Closing it from the value side means each of the 201 homes finishing at $586K rather than the $425K the model assumes — 38% more. Closing it from the cost side means getting all-in cost down from $405 to $294 per square foot.

A modeled RESIDE grant of $10.0M moves that threshold to $536K a home. That is still above the $425K assumed, leaving $22.4M uncovered, which is why the grant does not unlock this one.

Nor do all four levers have to move. For 282 Almaden Blvd, one alone would close the gap at:

Single-assumption flip points for 282 Almaden Blvd, each holding the other three at their defaults.

Average unit sizethe binding constraint — the least this building would need21% downto 595 sq ft
Completed value per home26% upto $536K
Conversion cost per square foot30% downto $183/sq ft

All four are sliders in the survey, where 282 Almaden Blvd re-scores against your own numbers.

How it compares in Downtown San Jose

282 Almaden Blvd ranks 57th of the 82 buildings screened here, against a median score of 64.

Its floor plate is better lit than 35% of them, and shallower than 30% of them at its deepest interior point. On size it is the 42nd largest by estimated homes. The full survey of all 82 buildings ranks and maps every one of them, and the list by address links each to its own page.

Within the DC zone

48th of 72 zoned DC — the comparison that shares its rules, rents and streets.

72 of the screened buildings are zoned DC. 282 Almaden Blvd ranks 48th of them against a median score of 61. 31 score 70 or more, their median deepest interior point is 68 ft from a facade against this building’s 79 ft, and together they would hold an estimated 23,276 homes. The group’s top scorer is 1 Almaden Blvd, at 100.

Its nearest match in size: 353 W Julian St

The screened building closest to 282 Almaden Blvd in converted floor area is 353 W Julian St: 293,355 sq ft over 9 stories, against 290,867 sq ft over 9 here.

282 Almaden Blvd scores 48 to its 53, and with the size held roughly equal most of that shortfall comes from interior depth: 2 out of 100 here, 21 there (deepest interior point 72 ft from a facade, scored from 80 ft down to 40 ft). On the money they sit in the same place: each falls short even with the modeled grant. The two stand about 3,900 ft apart.

Would it qualify for a RESIDE Act grant?

The model awards 282 Almaden Blvd $10.0M, on the assumption it qualifies. Whether it does, no published dataset can say.

That figure assumes the building meets the Act’s vacant-and-abandoned test, which turns on code-enforcement and receivership records no city publishes.

This building does sit in census tract 06085500800, a 2018 designated Opportunity Zone, which Section 201 lets HUD favor — one of the few statutory priorities this screen can actually check.

Other buildings screened near 282 Almaden Blvd

The 4 closest the screen also covers, from 270 ft away. They are the colored outlines on the plan at the top of this page.

  • 220 Almaden Blvd
    25 stories · 50% daylit · 776 estimated homes · scores 28/100 (Unlikely)
    about 270 ft away
  • 303 Almaden Blvd
    13 stories · 59% daylit · 292 estimated homes · scores 35/100 (Marginal)
    about 510 ft away
  • 185 Park Ave
    8 stories · 69% daylit · 143 estimated homes · scores 57/100 (Worth a feasibility study)
    about 600 ft away
  • 150 Almaden Blvd
    19 stories · 83% daylit · 228 estimated homes · scores 81/100 (Strong candidate)
    about 790 ft away

A screen, not a feasibility study, from outlines and heights rather than plans: the method and how to correct a figure. If you know this building’s interior, you know what this model cannot see.